Then i used the Vaccum former to create the tray.

Next i stuck both my cover and my sides onto the box using adhesive spray.

Next i printed out the sides of my box that i also made on Photoshop. I backed them using sticky back plastic. 

 Then i printed out the front cover design i made on Photoshop. I
printed it to my correct size that would fit on the lid. Then i used sticky
back plastic to cover my design so it becomes more durable.
I then stuck it onto the box using adhesive spray.

Then i put my box together using double sided tape.
i also put a magnetic stip along the inside of the lid and the base
so that the lid can shut and open properly

Then with my design i used the adhesive spray and stuck it on

to my grey board. 

I cut up some grey board to the size i needed. I then cut it in half using a Stanley knife, but then i stuck it back together using tape. I then picked some sugar paper to the colour of my choice which was orange. and stuck that on using the adhesive spray.

These two pictures are of my lid and my base of my final design.

I developed my box again because i wanted it to be more difficult and original. Although it looks like i have made a lot of changed i haven't really i have just made the box pieces seperate. i still have the lid attached and the shape has been kept the same. These to picutres are of the sides of my box.

i wanted to change my box design i changed it to this net. I feel this net is a lot more professional looking. i like how the lid is attached and there are not a lot of glue tabs on it.